Fig.6: Concrete Crack Repair by Drilling and Plugging. This technique is only applicable when cracks run in reasonable straight lines and are accessible at one end. This method is most often used to repair vertical cracks in retaining walls. A hole [typically 2 to 3 in. (50 to 75 mm) in diameter] should be drilled, centered on and following the ...

بیشتر

Method Statement for Pouring Concrete on Slab on Grade (S.O.G) Method Statement for Excavation Compaction and Backfilling | Civil Works; Method Statement for Formwork, Reinforcement and Concrete Works; MAPPING: A sketch of the surface defect shall be prepared indicating the location as reflected in the drawing.

بیشتر

GENERAL This following Method Statement covers surface preparation and repair of damaged or defective concrete surfaces for building works. 2. The repair method consists of Investigation and evaluation, concrete removal, preparation for repair, repair materials and concrete repair method and rehabilitation of concrete surfaces. 2.

بیشتر

Structural Lifting and Supporting Shotcreting Repair of Structural Members Damaged by Corrosion Concrete Patch Repair Epoxy Injections for Structural Cracks Repair of Expansion Joints Repair of concrete water tanks and waterproofing Structural Lifting and supporting This method of repairing of concrete involves mechanical lifting of settled ...

بیشتر

Complete template of method statement along with the related attachments can be downloaded here. Structured Method Statement for the Repair of Concrete. I. Description of Works 1. Introduction This method statement defines the sequence and the control procedures for the repair …

بیشتر

GENERAL This following Method Statement covers surface preparation and repair of damaged or defective concrete surfaces for building works. 2. The repair method consists of Investigation and evaluation, concrete removal, preparation for repair, repair materials and concrete repair method …

بیشتر

1. Preparation and Installation Slab On Grade Footing. A. Clean the area of any loose materials prior to start any work make sure that the compacted fill to received concrete is approved by the consultant Engineer. B. Check the dimensions and elevations from the approved shop drawing. C. Apply termite control according to manufacturer's ...

بیشتر

Method Statement for Pouring Concrete on Slab on Grade (S.O.G) Method Statement for Excavation Compaction and Backfilling | Civil Works; Method Statement for Formwork, Reinforcement and Concrete Works; MAPPING: A sketch of …

بیشتر

Method Statement. PIPE THROUGH WALL/SLAB REPAIR PROCEDURES Against a Flow of Water Active Leaking STEP 1: As shown in the drawing below chip a "U" shaped slot completely circling the through slab pipe or conduit. The slot is to be 1" (25 mm) wide by at least 1.5" (37 mm) deep. A "V" shaped slot is not acceptable.

بیشتر

PURPOSE The Main purpose of this Method Statement is to outline the repair procedure of structural concrete works for all building works in compliance with all the required specifications, standards, and proper construction procedures. 2. SCOPE OF WORK This document covers the work for the repair of structural concrete as follows: 2.1 Repair of ...

بیشتر

Background Surface Preparation Conmix dressing plaster LC 11 is a pre mixed sand cement mortar for internal and external use. It is recommended as finishing coats/repairing coats on to Portland cement based background, or render surface. LC 11 is ideal material for dubbing out and leveling of backgrounds or as an thin coat plaster. The…

بیشتر

Concrete Repair Method Statement (Structural Lifting, Shotcrete, Epoxy) Concrete repair refers to modification of structure which is damage in its appearance or serviceability. It also involves to restore the structure partly or wholly, the pre-existing characteristics of serviceability, load-bearing capacity and if necessary, to improve its ...

بیشتر

1. Title. Method Statement for Casting Slab on Grade. 2. Purpose and scope. The purpose of this method statement is to explain the proper procedure on how to prepare and cast slab on grade 1 or any horizontal element or member including fixation of steel reinforcement, MEP embedment's, fixing of shutter etc. without injuries. OTHER POSTS:

بیشتر

REPAIR YES REINFORCEMENT CHECK REINFORCEMENT NO ACCORDING TO SHOP DRAWING. CONCRETE CASTING. FINISH. 6 Method Statement Slab Ground Floor. 6.2. Sequence of Work a. Work Cycle of Wall Ground Floor. Casting is divided into 3 …

بیشتر

Method Statement PDF - 483 KB (en) SikaBond® T 55 (J) - Wood Floor Bonding. Method Statement PDF - 422 KB (en) Sikadur®- 752 - Cracks Repair For Concrete Slab. Method Statement PDF - 604 KB (en) Sikadur®-20 Crack Seal - For Concrete Repair. Method Statement PDF - 560 KB (en) Sikadur®-731 - Fixing starter-bar.

بیشتر

2.0 SCOPE This Method Statement applies to all the civil works - Excavation including ground preparation, setting out, backfilling, soil compaction, concreting, waterproofing, masonry, plastering, joinery, painting and GRC works - related to the construction of building as per project requirements, referring with approved Civil and MEP drawing.

بیشتر